We will remove the cable from the car's pedal (by pressing the lock on the cable and then removing it). 

Now we will attach the Nexcruise cable to the pedal of the car where it says TO ACC-PEDAL.    

We will attach the Nexcruise cable where the pedal cable was removed from the VCU PORT as it says TO VCU PORT.

To connect the cable attached to the car's pedal with the NexCruise unit, you need to plug in one end of the NexCruise cable labeled with NC-PORT A to the NC PORT-A of the NexCruise unit.            

 To connect the NexCruise cable to the VCU PORT of the car, you need to plug in one end of the NexCruise cable labeled with NC-PORT C to the NC PORT-C of the NexCruise unit.            

You need to plug in the state receiver that came with the NexCruise into the NC-PORT B of the NexCruise unit.

 You should leave NC-PORT D empty. (NC-PORT D is used for cars that require a brake sensor.)

You need to connect the OBD cable to the NC-OBD PORT labeled on the NexCruise unit and then connect the other end of the OBD cable to the OBD PORT of the car.

Once you connect the OBD cable to the car, the NexCruise unit will turn on and the 12V light will be lit up.

 After that, you should turn the car to the ACC mode (without turning the ignition on.

As soon as you turn the car to the Acc mode, you will see that the Sys light on the Nexcruise unit turns on and the state light on the LED bar turns on.